EverFocus EKR-KB1 - Handbuch (Seite 50)

Page 48 MNNCEKRKB1_0439
5.15 Controllin g the multiplexer using a video device
The multiplexer can be controlled using a new
generation video device (EKR-8/4, EKR-16/4).
In order to control a multiplexer in this way, the
MACRO protocol must be used.
V
AUX
MUX
In this case control may refer equally to the video matrix or the multiplexer. Therefore the choice of active
monitor should be made differently in each case.
5.15.1 Selecting a monitor connected to the video matrix
Press  , followed by the monitor number and if correct confirm with  .
After selecting a monitor the display will show the word  , followed by the monitor number.
Only monitors that have been defined as “enabled” in the

menu can be
requested.
5.15.2 Selecting a monitor connected to the multiplexer
To each multiplexer corresponds a single main monitor. To use the optional spot monitor see the respective
users’ manual..
If the multiplexer is identified by an address (Eneo multiplexer for example), press  , followed by the
multiplexer address and if correct confirm with  .
If the multiplexer is not identified by an address (a SP16C mux for example) press

and if
correct confirm with  .
After selecting a multiplexer the display will show the word  , followed by the multiplexer number.
Only multiplexers that have been defined as “enabled” in the  menu can be
requested.