Using the accessories (see ill. d), Cleaning and care – Parkside PABK 60 A1 Benutzerhandbuch
Seite 11
11
GB/IE/CY
Using the accessories (see Ill. D)
Air mattress adapter
6
, ball needle
12
Use a pipe wrench to unscrew the nozzle
9 a
of
the air blow gun
9
.
Then – depending on what is needed – screw
on the air mattress adapter
6
or the ball nee-
dle
12
, as well as the thread adapter
7
into
the barrel of the air blow gun
9
.
Universal valve connection
10
Screw the universal valve connection
10
directly
onto the compressed air hose
8
.
Cleaning and care
Thoroughly clean the spray stylus
3
immedi-
ately after use. Otherwise the paint can dry and
cause problems during the next use.
Thoroughly rinse out the spray stylus
3
with
water.
Use the thinner included to clean any stubborn
dried paint.
Note: The thinner is not suitable for water-so-
luble paints. Rather, it corresponds to a varnish
for thinning paints containing solvents.
Note: If you remove the paint nozzle of the
air blow gun
9
during cleaning, lubricate the
threads before reattaching it so its freedom of
movement is not affected.
Never lay the entire air blow gun
9
in a sol-
vent bath.
Note: If the air intake of the compressor should
become dirty, use a dry cloth to remove the ac-
cumulated dirt.
Fault
Interrupted paint jet
or intermittent paint
delivery
Cause
Solution
1. Paint almost
empty
1. Fill paint
2. Paint too viscous 2. Lower viscosity
3. Dry / defective
nozzle
3. Screw in nozzle tightly
or replace
Fault
Interrupted paint jet
or intermittent paint
delivery
Cause
Solution
4. Paint supply
restricted
4. Cleaning
5. Incorrect posi-
tion of spray
stylus
3
.
5. Correct position angle
Fault
Spray pattern
incomplete
Cause
Solution
1. Air head
dirty / defective
1. Clean / replace air head
1. Rinse with clear water
2. Nozzle dirty /
defective
2. Clean / replace air
nozzle
Fault
Spray pattern irregu-
lar with drips
Cause
Solution
1. Defective nozzle 1. Replace nozzle. Contact
a respective service centre.
2. Paint too viscous 2. Lower viscosity
3. Insufficient
working pres-
sure
3. Increase working pres-
sure (if necessary, not in-
cluded accessories, e.g.
pressure reducer)
3. Hose defective; replace
hose
Fault
Non-uniform paint
amount delivered
Cause
Solution
Nozzle dirty /
defective
Clean / replace air nozzle
Preparations for use / Cleaning and care
Preparations for use
73868_par_Airbrush_Set_Content_GB-IE-CY.indd 11
06.07.12 12:26