Parkside PGG 15 A1 - Handbuch (Seite 8)

8 GB/IE/CY
General safety advice for electrical power tools Introduction / General safety advice for electrical power tools
Wear ear protection!
Evaluated acceleration, typical:
Hand / arm vibration: 1.582 m / s
2
Uncertainty K = 1.5 m / s 2
The vibration level specified in these instructions was
measured in accordance with an EN 60745 standardised measurement
process and can be used to compare equipment. The vibration emission
value specified can also serve as a preliminary assessment of the ex-
posure.
The vibration level will change according to the application of the elec-
trical tool an in some cases may exceed the value specified in these in-
structions. Regularly using the electric tool in such a way may make it
easy to underestimate the vibration.
Note: If you wish to make an accurate assessment of the vibration
loads experienced during a particular period of working, you should
also take into account the intervening periods of time when the device
is switched off or is running but is not actually in use. This can result in
a much lower vibration load over the whole of the period of working.
General safety advice for
electrical power tools
Read all the safety advice and
instructions! Failure to observe the safety advice and in-
structions may result in electric shock, fire and / or serious
injury.