Parkside PHD 100 C2 - Handbuch (Seite 8)

8
GB CY IE
• If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer, a customer service agent
of the same or a similarly qualiied per-
son in order to prevent hazards.
• Do not pull the plug from the socket by
the cable. Protect the cable from heat,
oil and sharp edges.
• Do not carry or ix the equipment by
the cable.
• Use only extension cables that are pro-
tected from spray water and designed
for outdoor use. Always fully unroll a
cable drum before use. Check the ca-
ble for damage.
• Before any work on the equipment,
during work breaks and in the case
of non-use, remove the plug from the
socket.
• The machine shall be disconnected
from its power source during cleaning
or maintenance and replacing parts or
conerting the machine to another func-
tion.
• The cross-section of the power supply
cable must not be less than 2 x 2,5
mm².
• Wear sturdy footwear to protect
against electric shock.
Start-up
In keeping with current regulations
a pressure washer must never be
operated off the drinking water
mains supply without a controlla-
ble backlow preventer. A suitable
backlow preventer in conformity
with EN 12729 type BA must be
used.
Water that has passed through a backlow
preventer is classiied as undrinkable.
• Water that has passed through a back-
low preventer is classiied as undrink-
able.
• High-pressure hoses, ittings and
couplings are important for machine
safety. Use only high-pressure hoses,
ittings and couplings recommended by
the manufacturer.
• To ensure machine safety, use only
original replacement parts from the
manufacturer or replacement parts au-
thorised by the manufacturer.
Electrical safety:
Caution: to avoid accidents and
injuries from electric shocks:
• The plug and socket of an extension
cable must be water-tight!
Unsuitable extension cables can
be dangerous as people can be
harmed by an electric shock!
• Protect the electric plug connections
against moisture.
• If there is a risk of looding, ix the
plug connections in an area that is safe
from looding.
• Ensure that the mains voltage matches
the speciications on the rating plate.
• The electrical installation shall be ac-
cording to national wiring rules.
• Connection to the mains must be car-
ried out by an experienced electrician
and meet the requirements of IEC
60364-1.
• The device must only be connected to
a mains socket via a residual-current
circuit breaker (RCD) with a rated leak-
age current of not more than 30 mA.
Fuse: at least 13 ampere.
• Before each use, check the equipment,
cable and plug for damage.