Metz LCD-TV 20 TM 52 - Handbuch (Seite 44)

- 40 -
Before Switching on your TV
Power connection
68Ãhqhƒ‡r
U‚ÃQPX@S
DIQVUÃ 98Ã !ÃW
‡r €v hy
IMPORTANT: The TV set is designed to op-
erate on 12 V DC. For this, an adaptor is
used which gives 12V DC voltage. Connect
this adaptor to a system that supplies
230V AC, 50 Hz.
• After unpacking, allow the TV set to reach the
ambient room temperature before you con-
nect the set to the mains.
Connections to the RF input
socket
9+)8+)
:
UWÃS@6SÃQ6I@G
867G@ÃUWÃ
• Connect the aerial or cable TV plug to the
RF input socket located at the back of the TV
and connect the cable plug coming out from
the TV out socket located at the devices
(VCR, DVB etc.) to this socket as well.
How to connect other devices
IMPORTANT: Switch off the TV before con-
necting any external device.
Sockets for external connections are at the
back of the TV. For connection of other de-
vices via Euroconnector refer to the manuals
of the related devices.
Inserting batteries in the remote
control handset
• Remove the battery cover located on the
back of the handset by gently pulling up-
wards from the indicated part.
• Insert two AAA (R03) or equivalent type of
batteries inside.
• Replace the battery cover.
NOTE: Remove battery from remote control
handset when it is not to be used for a long
period.Otherwise it can be damaged due to
any leakage of battery.
Switching the TV ON/OFF
To switch the TV on:
Your TV will switch on in two steps:
1- Connect the power supply cord to the sys-
tem. Press the “ ” button at the top of the
TV. Then the TV switches itself to stand-by
mode and the led becomes red located on
the front of the TV.
2- To switch on the TV from stand-by mode
either:
Press a digit button on the remote control so
that a programme number is selected,
or,
Press “-P/Ch” or “P/Ch+” button at the top
of the TV or press “-P/CH” or “P/CH+” button
on the remote control, so that last switched
off programme is selected.
By either ways the TV will switch on and the
led becomes green.