Parkside PGG 15 A1 - Handbuch (Seite 13)

14 GB/IE
Operation
Switching on:
˽
Press the ON / OFF switch 1 .
Switching off:
˽
Release the ON / OFF switch 1 .
© Setting the stroke rate
The stroke switch 2 is used to set the penetration depth of the engrav-
ing. A low setting is normally adequate for most engraving tasks.
˽
Turn the switch for the number of strokes 2 in the + direction to
increase the penetration depth.
˽
Turn the switch for the number of strokes 2 in the – direction to
decrease the penetration depth.
© Changing the engraving point
WARNING! RISK OF INJURY! Switch the device off before
performing any tasks on the device and pull the mains plug out of the
mains socket.
˽
Replace the engraving point 5 as soon as it becomes too worn
and no longer provides the desired engraving performance. Turn
the engraving point holder
6 anticlockwise until the engraving
point 5 is released.
˽
Insert a new engraving point 5 and turn the engraving point
holder 6 clockwise to lock the engraving point in position.
˽
Ensure that the engraving point 5 is properly fixed in position.