AEG ELECTROLUX L 56840 - Handbuch (Seite 12)

Cancelling a programme
Turn the selector dial to to cancel a programme which is running. Now you can select a
new programme.
Altering an option or a running programme
It is possible to change any option before the programme carries it out. Before you make
any change, you must pause the washing machine by pressing the button 5.
Changing a running programme is possible only by resetting it. Turn the programme selec-
tor dial to
and then to the new programme position. Start the new programme by
pressing the 5 button again. The washing water in the tub will not emptied out.
At the end of the programme
The machine stops automatically. The light of button 5 and the light 7.1 go off. The phase
light 7.2 illuminates.
If you have set a programme or an option that ends with water in the tub, the correspond-
ing pilot light remains lit. The phase light 7.2 goes on. The door remains locked. The water
must be emptied out before opening the door. During this time, the drum continues to turn
at regular intervals until water drain.
To empty the water out:
• turn the programme selector dial to
• select the DRAIN or SPIN programme
• if necessary, reduce the spin speed if needed
• press button 5
• when the programme has finished only the pilot light 7.2 comes on.
Turn the programme selector dial to
position to switch the machine off. Remove the
laundry from the drum and carefully check that the drum is empty.
If you do not intend to carry out another wash, close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant smells.
Stand by: once the programme has finished after a few minutes the energy saving system
is enabled with the pilot lights switched on. By pressing any button the appliance will come
out of the energy saving status.
12