Zanussi ZWF 1422 - Handbuch (Seite 11)

Ink : depending on the type of ink, moisten the fabric
first with acetone
1) , then with acetic acid; treat any re-
sidual marks on white fabrics with bleach and then
rinse thoroughly.
Tar stains : first treat with stain remover, methylated spi-
rits or benzine, then rub with detergent paste.
Open the door by carefully pulling the door handle
outwards
Load the laundry
Place the laundry in the
drum, one item at a time,
shaking them out as
much as possible.
Maximum Loads
Recommended loads are indicated in the «Wash-
ing Programmes».
General rules:
• Cotton, linen : drum full but not too tightly packed;
• Synthetics : drum no more than half full;
• Delicate fabrics and woollens : drum no more than
one third full.
Close the door gently
Warning! Make
sure that any fab-
rics were not trapped
when closing the door.
Detergents and additives
Good washing results also depend on the choice of de-
tergent and use of the correct quantities to avoid waste
and protect the environment.
Although biodegradable, detergents contain substances
which, in large quantities, can upset the delicate bal-
ance of nature.
The choice of detergent will depend on the type of fabric
(delicates, woollens, cottons, etc.), the colour, washing
temperature and degree of soiling.
All commonly available washing machine detergents
may be used in this appliance:
• powder detergents for all types of fabric,
• powder detergents for delicate fabrics (40°C max)
and woollens,
• liquid detergents, preferably for low temperature
wash programmes (60°C max) for all types of fabric,
or special for woollens only.
Quantity of detergent to be used
The type and quantity of detergent will depend on the
type of fabric, load size, degree of soiling and hardness
of the water used.
For the quantity of detergent, refer always to what is writ-
ten on the product packing.
Use less detergent if:
• you are washing a small load,
• the laundry is lightly soiled,
• large amounts of foam form during washing.
Degrees of water hardness
Water hardness is classified in so-called “degrees” of
hardness. Information on hardness of the water in your
area can be obtained from the relevant water supply com-
pany, or from your local authority.
If the water hardness degree is medium or high we sug-
gest you to add a water softener following always the
manufacturer’s instructions.
When the degree of hardness is soft, readjust the quan-
tity of the detergent.
Open the detergent dispenser drawer
Compartment for
powder or liquid deter-
gent used for main
wash. Compartment
for liquid additives (fabric
softener, starch).
11