Zanussi ZWN7140AL - Handbuch (Seite 24)

Positioning
Install the machine on a flat hard floor. Make
sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that
the machine does not touch the wall or other
kitchen units. Level the washing machine by
raising or lowering the feet. The feet may be
tight to adjust as they incorporate a self locking
nut, but the machine MUST be level and stable.
Any necessary adjustment can be made with a
spanner.
Accurate levelling prevents vibration, noise and
displacement of the machine during operation.
Never place cardboard, wood or similar materi-
als under the machine to compensate for any
unevenness in the floor.
If necessary, check
the setting with a spi-
rit level.
Rubber feet kit (4055126249)
Available from your authorized dealer.
The rubber feet are particularly recommended
on floating, slippery and wooden floors.
Mount the rubber feet to prevent vibration,
noises and displacement of the appliance dur-
ing operation.
Read carefully the instructions supplied with
the kit.
Water inlet
Caution!
• This appliance must be connected to a
cold water supply
• Before connecting up the appliance to
new pipework or to pipework that has
not been used for some time, run off a
reasonable amount of water to flush out
any debris that may have collected
• Do not use the hose from your previous
appliance to connect to water supply.
The inlet hose is supplied with the appliance
and can be found inside the machine drum.
35°
45°
Open the porthole and extract the inlet hose.
Connect the hose with the angled connection
to the machine. Do not place the inlet hose
downwards. Angle the hose to the left or right
depending on the position of your water tap.
Set the hose correctly by loosening the ring
nut.
Connect the hose to
a tap with a 3/4”
thread.
• After positioning the inlet hose, be sure to
tighten the ring nuts again to prevent leaks.
• The inlet hose must not be lengthened. If it
is too short and you do not wish to move
the tap, you will have to purchase a new,
longer hose specially designed for this type
of use.
24
www.zanussi.com