ABUS CASA10010 - Handbuch (Seite 26)

26
English
“12345”, the port must be set to 8000.
After successfull login to IP alarm module webinterface in the setup screen appears.
Now click on “network” to change the IP address of the alarm module.
To change the IP address please go to “Device IP Address”. The IP configuration is finished after saving
now.
5.2 How to learn in the wireless remote control / wirless detectors
Open the housing of the IP alarm module and start to learn 2-way components into IP alarm module.
First the remote control should be learnd in to the IP alarm module.
Press „Select“. Now the bottom light is blue. Now you´re in the programming menu 1.
Then choose the channel by pressing “Set” button.
Select the “Channel Group 1” as a group for the controls and the “Channel Group 2” as a group for the
detectors.
Channels 1-4 are assigned to channel group 1. Program the first LED for using the remote
control. Now you learn in the radio remote control by pressing a button SET or UNSET
button on remote control and point it towards the infrared sensor located on IP
alarmmodule.
To quit the programming menu press “ESC/DEL” once.
If the remote control should be also receive a confirmation when the remote device (recorder / camera) will
be activated/deactivated (LEDs lights up for status “activated” or “deactivated”), you have to reserve an
output on the IP alarm module.
Signal is sent Signal is received
The IP alarm module peeps twice if the component is learnd in successfully.