WolfVision VZ-9plus 3 User Manual - Handbuch (Seite 16)

15
RGB Port
1 - Analog Red video 6 - Red return 11 - N/C Not connected
2 - Analog Green video 7 - Green return 12 - SDA I²C data
3 - Analog Blue video 8 - Blue return 13 - HSync Horizontal sync
4 - N/C Not connected 9 - SENSE +5 V DC from Visualizer 14 - VSync Vertical sync
5 - GND Ground 10 - GND Ground (VSync, DDC) 15 - SCL I²C clock
1
11
5
15
15-pin D-Sub HD
connector female
(front side, unit)
The EXTERN input (#24) has the same pin assignment as the RGB output (#22).
External Input - EXTERN
A computer can be connected to the External RGB input (#24) of the Visualizer.
By
the Visualizer displays the signal from the external input to the
audience. To switch back to the live image of the Visualizer use the EXTERN key on the camera head
or the VZ key on the remote control.
The Visualizer has a built-in A/D-converter in order to digitize the analog RGB signal from the computer and
output it on the RGB and DVI outputs in the selected signal format.
Preferred resolution is: SXGA- (1280x960) @60Hz
Supported resolutions from VGA (640x480@60Hz) to with several resolutions
and refresh rates in this range.
Following data are provided:
Plug & Play Monitor VESA DDC
Monitor name: "WolfVision"
Video Input Definition: Analog at 0.7Vpp and separated synchronization signals
Vertical range limits: 48Hz - 86Hz
Horizontal range limits: 30kHz - 121kHz
Maximum pixel clock: 170MHz
Gamma: 2.2
Preferred resolution: SXGA- (1280x960) @60Hz
pressing the EXTERN key (#39 or #50)
(#50)
(#33)
The Visualizer can be used for a "Live Picture to External Picture Comparison" on two monitors or beamers.
While one monitor or beamer displays the signal of the external source and the other displays the live image
of the Visualizer.
The settings of the Visualizer can be changed in the on-screen menu (see page 16).
WXGA+ (1440x900@60Hz)
The output level on VGA and Preview output can be adjusted to match exactly 700mV. This can be helpful
to balance different image brightness i.e. when using external input.
For exact adjustment, please use external measurement equipment.
Range: 85% to 100% (on-screen extra menu - see page 16)
The complete serial protocol can be found on our internet website under: www.wolfvision.com/support
The serial port (#18) can be used to control the Visualizer through an external device, such as a room
control system that is used to integrate conference rooms.
Pins: 2: RX, 3: TX, 5: GND
Baud Rate: 9200, 19200, 38400, 57600 or 115200 (selectable)
databits: 8, stopbit: 1, parity: no
The baud rate can be changed in the on-screen extra menu by keeping pressed the
menu key until it appears (see page 16).
RS-232, Serial Control Input
9-pin D-Sub connector
on unit male
(front side)
5
9
1
6