WolfVision VZ-C3D User Manual - Handbuch (Seite 6)

5
#16 MENU key
Pressing MENU key activates the on-screen menu (see page 13).
#17 MENU NAVIGATION keys
For navigating through the on-screen menu (see page 13).
#18 3D key
To toggle image output between different 3D / 2D modes (see page 12).
#19 PRESET keys (programmable settings)
For storing a preset, press one of the PRESET keys for more than 2 seconds.
For recalling a preset, press the PRESET key quickly (see page 9).
#20 Manual IRIS keys (brightness adjustment)
When the IRIS keys are pressed, the Visualizer switches off the auto iris function. The next time the ZOOM
keys are used the auto iris is switched on again (see page 9).
For specialists: The behaviour of the iris can be changed in the on-screen menu.
The overall iris level can be changed in the on-screen menu (see page 13).
#21 AUTO FOCUS (AF) key
Pressing this key activates the Auto Focus (see page 9).
#22 Manual FOCUS keys
For focusing the picture (see page 9).
#23 LASER POINTER indication LED
Indicates active Laser LED.
#24 LASER POINTER key
Important: Do not stare directly into the laser beam. This is hazardous for your eyes!
#25 ZOOM keys
Using the ZOOM keys also switches auto iris on again.
#26 VERG keys
To adjust the (Con)vergence / deepth of the 3D effect (see page 12).
#27 FREEZE key
Freezes the current image (see page 9).
#28 OK key (Enter)
To confirm menu settings and to enter menu sub menus (see page 13).
#29 POWER key
Pressing this key switches the unit on and off.
When switching on the unit, the Visualizer runs the power-on preset.
Keys on the IR-Remote Control
If you want to work with more than one Visualizer in the same room, the units should be set to different
infrared codes, in order to control them all individually.
The IR code of the Visualizer has to match the code of the remote control.
To change the IR code, enter the "Advanced Settings / Miscellaneous Settings" and
set the "IR Code" to A, B, C or D (code A is default). To change the IR code on the remote control,
simultaneously press PRESET 1, PRESET 2
and ZOOM TELE
ress PRESET 1, PRESET 2 and ZOOM WIDE
on-screen menu, go to
(#19) (#25). Each time this key
combination is used, the code switches from A to B, C, D ... A ...in the given order.
For resetting the remote control to code A, simultaneously p
.
The LED shows the selected code (it flashes one time for code A, two times for code B, three times for code
C and four times for code D).
Different IR Codes