Elitegroup 321 - Handbuch (Seite 34)

Press the [Enter] key and disconnect the AC adapter then press the
[Y] key until you hear continuous battery low-low warning beeping
sounds. The system will be fully discharge and shutdown completely.
3.
4.
5.
6.
Connect the AC adapter and let the battery fully recharge. The
“Battery Charge LED” which is located at the right side of the
notebook will light indicating it is in charging status.
When the battery charge LED turns off will indicate the system is
fully charged.
Repeat step 1 to 4 once again.
The battery is now fully calibrated.
Resetting the System
After installing a software application package, you may be prompted to
reset the system to load the changed operating environment. To reset the
system, or “reboot,” press the [Ctrl]+[Alt]+[Delete] keys simultaneously.
This is known as “warm boot.” This key combination acts as “software”
reset switch when you encounter hardware or software problems, which
lock up the Notebook.
If this key combination does not shut down the Notebook, you can reset
the Notebook by using the Notebook’s power button. Should the
Notebook lock up for some reason, pressing this button powers the
Notebook off.
Adjusting the Brightness
To adjust the brightness on the LCD screen, press and hold down the [Fn]
key in the lower left hand corner of the keyboard and press the [F7] key
to reduce the brightness or [F8] to increase the brightness.
32