Festo Линейные модули HMP - Handbuch (Seite 25)

HMP−...−B−...−Z..−...
Festo HMP−...−B−...−Z..−... 0412NH English
25
Accurate adjustment of the intermediate position and correction of the end
position:
Please note
S Consider the following points:
Ĉ You can carry out accurate adjustment of the intermediate position by
turning the shock absorber sleeve (if two intermediate position modules are
used, accurate adjustment is only possible if the directions of approach are
different).
Ĉ The end position will be modified when the intermediate position is set and
must be readjusted (readjustment must be made on the stop).
Setting the intermediate position on
the shock absorber Correcting the end position on the
stop
(a)
3
(a)
4
1. Loosen the clamping screws 3 by
2 turns.
2. Turn the shock absorber sleeve
(and the shock absorber) with a
wrench until the desired position is
reached (observe the maximum
value (a) as specified in the table
below).
3. Tighten the clamping screws 3
(tightening torque see table).
1. Loosen the clamping screws 4 by
2 turns.
2. Turn the stop with a wrench until
the desired end position is reached
(observe the maximum value (a) as
specified in the table below).
3. Tighten the clamping screws 4
(tightening torque see table).
4. Fasten the housing cover again.
5. Exhaust linear module type HMP−...−B−...Ă.
Fig. 16