ADAM Audio S2A - Handbuch (Seite 8)

8
Controls
INPUT GAIN
To match the monitor’s input to the source signal level, the input sensitivity can be
varied by -10 dB to +10 dB.
ROOM EQ
A detailed way to optimize the reproduction for the room are the two shelve filters
at both ends of the frequency band. Above or below the given cut off frequency the
amplitude is progressively changed. The given dB values occur at 30 Hz and 15 kHz. We
show five curves, the controls can be changed continuously however.
HIGH GAIN
The voltage gain of the tweeter amplifier and thus the complete tweeter level can be
varied in a ±4 dB range. This is a considerable change in the sound characteristic and
should be used with caution. In case you have a considerably damped room or if there
is a special taste you are after this control will serve you well.
ROOM EQ >6 kHz Shelve Filter
with 6 kHz cut off frequency
ROOM EQ <150 Hz Shelve Filter
with 150 Hz cut off frequency