ADAM Audio Epsilon Semi-active Version - Handbuch (Seite 9)

9 Tensor Epsilon (Semi-active Version) Manual / english
4.1 LED
On the bottom of the tweeter you find an
LED. It indicates Power on and, in case of
an overload, the function of the protective
circuit.
Please note: When the speaker is switched
on, the LED will flash red a few times. This
does not indicate an overload.
• The LED starts to glow green during normal operation (the power switch is
located on the rear side of the speaker).
• In case of an overload, the OL LED will flash red. The protective circuit will safe
your speaker from damage.
4.2 Controls
On the rear side you will find controls that
allow detailed fine-tuning of your loudspeakers
to your particular room acoustics and per-
sonal listening preferences. The following
tips are intended to assist you at using the
controls in the best manner.
Please note that using the controls may
have a great impact on the overall sound
characteristics of your loudspeakers. We
recommend using the controls with utmost
care and only after several audio tests with
familiar recordings.
4.3 Mode
This button allows you to choose between
• Signal On: woofer starts operation as soon as a musical
signal arrives, and stops after 15 minutes without a signal.
• Continuous: the unit is permanently working. We
recommend the ”Signal on” position. It minimises power
consumption and makes handling very easy.
4. Speaker Adjustment
LED