Weidmuller SFI - 1 channel signal isolator - Handbuch (Seite 13)

1
•Modifications
Changingtheinputoroutputrange
To change the input or output range:
1. Remove the four screws holding the front panel in place (marked A &
B in the diagram below).
. Remove the front panel. Take care not to lose the plastic insulators
which fit over the potentiometer screws - they are essential to
maintain specified isolation.
. Select the switches according to the tables below.
Input
SwitchBankS1
Output
SwitchBankS2
lK4
Bit1 Bit2 Bit3 Bit4 Bit1 Bit2 Bit3 Bit4
4-20 mA ON OFF OFF OFF 4-20 mA OFF OFF OFF ON OFF
0-20 mA OFF OFF OFF ON 0-10 V OFF ON ON OFF OFF
0-10 V OFF OFF OFF OFF 0-5 V OFF ON ON OFF ON
±10 V OFF ON ON OFF
4. Replace the front panel.
. Calibrate the unit. LEFT HAND SIDE VIEW
D
E
G
H
B
A
C
F