Clearaudio BALANCE AMPLIFIER - Handbuch (Seite 14)

Balance Amplifier
Bedienungsanleitung/Instruction Manual
Seite/Page 14  clearaudio electronic GmbH 2006
2. Front view and operating elements
1
LED „Overheat” lights up if the amplifier is overheating, at the same time
the speaker output will be shut down. If the amplifier cools down, it will be
switched on automatically.
2
LED „Short” lights up in case of overload (to small impedance from the
connected speakers).
3
LED „DC Out” lights up it DC voltage on the speakers output e. g. by a
damage of the amplifier, resp. short after power up the amplifier.
4
LED „Power” lights up when the amplifier will be switched on with the
„Standby/On”-power button.
5
LED „Standby” lights up if the power switch on the rear side if the amplifier
is in the standby-mode.
6 Switch „Standby/On” indicates „Standby”.
7 LED „Bridge” lights up if the amplifier is used in the bridged mode.
1
2
3
4
5
6
7