Clearaudio BALANCE AMPLIFIER - Handbuch (Seite 19)

Balance Amplifier
Bedienungsanleitung/Instruction Manual
Seite/Page 19  clearaudio electronic GmbH 2006
On the front side glowes the „Standby-LED” (5). If you press the power button (6) into
the amplifier turns into the normal mode and both LEDs „Power” (4) glowe.
Temporary, for circ. one second both LEDs „Short” (2) will glowe if you turn the
Amplifier on, this is not a defect!
After 4-5 seconds the output relays for the speakers outputs will stretch and the
amplifier will be ready.
If you turn off the amplifier for a short time, please use the „Standby/On” (6) button on
the front side, for a longer time (several days) please use the „Power” switch on the
back side to power off the amplifier completely.
5. Service and special informations:
In case of any necessary service for all clearaudio products should be done by
authorized personal only.
In case of any repair, the clearaudio Balance Amplifier needs to be sent to your nearest
authorized dealer or directly to the clearaudio factory.
Send / ship the
Balance Amplifier always and only in the original packing!!! Only in the
original packing clearaudio can provide the warranty.
To achieve the full clearaudio warranty, it is necessary that you fill out and send the
corresponding part of the warranty registration card back to clearaudio, within two
weeks after purchase. Only if the product is returned in its original packing clearaudio
can provide the warranty.
6
4
4
13
6
2
2
5