Citizen Systems CBM-820 - Handbuch (Seite 35)

– 20 –
4.9.3 Producing a test print
The following procedure can be used at any time to test the printer.
❏
Turn on the printer and insert a piece of paper (page 11, 16).
❏
Turn off printer power.
❏
While holding down RELEASE, turn printer back on. Keep RELEASE
depressed for a few moments until the printer beeps and the printer test
print starts.
The printer test will continue until it reaches the end of the paper.
4.9.4 Adjusting the dot alignment
You may never have to use the procedure described in this section, but after you
have been using your printer for some time you may find that the dots of some
graphics do not align correctly. For example, what should look like:
may come out looking like one of the following:
or like this