faytech 10'' Touch Monitor V1.1 - Handbuch (Seite 55)

55
Please note that extended desktops often are black in the beginning. In this situation your
display may be black at first if you configure it as an extended desktop.
Tip: It is often best to use the display at the following resolutions: 7” 800x480 or 800x600,
8” 800x600, 10” 1024x768, all at 60Hz. If the display is used as a second display with a
PC, which is already connected to a display with a much higher resolution, configure
resolution profiles. With an ATI graphic card, you can set up profiles in the advanced
catalyst control center under profiles. Activate a hotkey, so that you can change the
profiles of each display (one is the touch display, the other is the higher resolution display).
Also you can configure the profiles using a software tool such as powerstrip.
 Power supply error:
If the display has no signal input, there might be an error with the power supply. First please
check the connection with another power supply before you return the display. We're happy to
exchange the defective power supply if necessary.
Stripes / errors in the image
 Pixel error:
Each faytech display has been thoroughly tested and sold with no pixel defects. If there is a
pixel error at your display, please contact us for Support.
 Text is hard to read, picture looks fuzzy:
The display image is in the original resolution (see specifications) clear. At higher resolutions
the display interpolates. This leads to inaccuracies and picture distortions.
 Stripes / errors in the image:
When connecting the display using power from a PC's power supply, the power supply can
cause a light flickering. This is because of the interference created by the PC's power supply.
In order to improve the picture, please try an alternative power supply.
 image is upside down:
Press (when there is a signal) the + button. This switches through four different modes (the
original, top / bottom mirrored, left / right mirrored)