Upgrading the datalink module, Checking the upgrade – TeeJet LH DataLink Upgrade Instructions Benutzerhandbuch
Seite 5
E
NGLISH
LH A
GRO
5
UPGRADING THE DATALINK MODULE
To upgrade the DataLink Module follow this simple procedure:
Step Description
1
Switch the DataLink and LH 5000 off if not already turned off.
2
Insert the upgrade card into the DataLink module.
3
Switch the DataLink module and the LH 5000 on.
4
The upgrade is complete when the GPS main menu is displayed on the
LH 5000.
CHECKING THE UPGRADE
After upgrading the DataLink module it is a good idea to check that the upgrade
has been installed, this is done as follows:
Step Description
1
Press the STATUS-key on the LH5000
2
The screen to the left is displayed.
The DataLink software version can be seen at the
bottom of the display.
3
Cross check that the software version displayed is the same as the
version written on the datacard.
4
Please contact LH Agro if the version numbers differ.