AUDIOLINE TEL 5 clip - Handbuch (Seite 23)

- Setting up -
23
3 Setting up
3.1 Safety Information
Caution: Before setting up, it is essential that you
read the General Information at the beginning of
this manual.
3.2 Check contents of pack
The following items are supplied:
one telephone base one telephone receiver
one telephone connecting
cable one spiral cable
one instruction manual three AA batteries
3.3 Connecting the receiver
After unpacking your telephone, you must first connect the
telephone receiver to the telephone base. First take one end
of the spiral cable and plug it into the socket at the bottom of
the receiver. Turn the telephone over and plug the other end
into the lower socket (see Chapter 2, Section entitled
Underside of base unit, Item 4.). Bring the cable out via the
cable duct.
3.4 Fitting the batteries
Before connecting your new telephone to the telephone
network, the batteries should be fitted. Please always use a
good type of AA batteries. No messages will be shown in the
display if the batteries are not fitted. Before installing or
changing the battery, make sure that the telephone is not
connected to the telephone network.
1. The battery compartment is to be found on the
inside of your telephone base.
2. Open the battery compartment with a small
screwdriver or a pointed object.
3. Insert the batteries, ensuring that the polarity is
correct.
4. Close the battery compartment.
The battery should be changed when the
\ symbol
appears in the display. All three batteries must then be
changed. If the batteries become discharged, the display will
go dark.
3.5 Connecting the telephone
Connect the telephone cable supplied to the telephone
socket and the telephone jack on the underside of the