AUDIOLINE TEL 5 clip - Handbuch (Seite 25)

- Operation -
25
4 Operation
4.1 Making a call
Your telephone can be used like any conventional
telephone.
1. Lift the receiver and wait until you hear the dialling
tone.
2. Now dial the required telephone number. The
display can show a telephone number with a
maximum of 14 digits. If the number dialled is
longer than this, only the last 14 digits will be
displayed.
3. To end the call, replace the receiver on the rest.
You can end the current call by using the
disconnect button and you will immediately obtain
a new dialling tone.
4.2 Receiving calls
When a call comes through, you will hear the ringing tone.
The call can now be accepted using the receiver.
4.3 Call Duration Display
The call duration is shown in the display in minutes and
seconds during a call. The indication starts after the number
has been dialled. The call duration still remains showing in
the display for a few seconds after the call has been ended.
4.4 Adjusting the receiver volume
If the receiver volume is too quiet or too loud for you, you
can change this to suit your requirements.
You can adjust the volume from soft
to loud using
the VOL. slide switch on the receiver.
4.5 Redial facility
If a connection that you have dialled is engaged or you were
unable to get through to anybody, simply replace the
receiver. The last number dialled remains stored in the
telephone automatically. To use the redial facility, proceed
as follows:
Lift the receiver and press the redial button
F. The stored
redial number will now be dialled.
4.6 Adjusting the receiver volume
By means of the slide switch on the right side of the
telephone base you can choose the settings (loud) or
(soft) to match the volume of the ringing tone to your
requirements. If at any time you do not want to be disturbed,
use the (off) setting.