Parkside PWS 1010 - Handbuch (Seite 7)

6 GB/IE/CY
Introduction
Angle grinder PWS 1010
Grinding, roughing, cutting
© Introduction
Please make sure you familiarise your-
self fully with the way the device works
before you use it for the first time and
that you understand how to handle electrical pow-
er tools correctly. To help you do this please read
the accompanying operating instructions. Keep
these instructions in a safe place. If you pass the
device on to anyone else, please ensure that you
also pass on all the documentation.
© Proper use
The device is intended for the dry cutting, rough
grinding and brushing of metal and stone. Any other
use or modification to the device shall be considered
as improper use and could give rise to considerable
dangers. We will not accept liability for loss or
damage arising from improper use. The device is
not intended for commercial use.
Note: Slots cut in load-bearing walls must comply
with standard DIN 1053 Part 1 or the regulations
applicable in your country.
These instructions and advice must be observed.
Before you start a task, seek the advice of a com-
petent structural engineer, architect, or the relevant
site management staff.
© Features and equipment
1 Safety lock-out
2 ON / OFF switch
3 Carbon brushes cover
4 Auxiliary handle
5 Adjustable disc guard
6 Clamping nut
7 Mounting spindle
8 Mounting flange
The following pictograms are used in these operating instructions / on the device:
Read instruction manual! Safety class II
Observe caution and safety notes! Proper procedure and handling.
Caution – electric shock!
Danger to life!
Wear hearing protection, dust
protection mask, protective glasses
and protective gloves.
Risk of explosion!
Keep children away from electrical
power tools!
Risk of fire! For indoor use only!
V~
Volt (AC)
Risk of loss of life by electric shock
from damaged mains lead or mains
plug!
W
Watts (effective power)
Dispose packaging and appliance in
an environmentally-friendly way!
n
0
Rated idle running speed