Before use, Insert / change battery, Operating instructions – Tronic H12276 Benutzerhandbuch

Seite 8: Measuring d, c, aa and aaa battery, Measuring 9 v battery

Advertising
background image

8 GB/CY

Safety Information / Before use / Operating instructions

J

Remove a spent battery immediately from the device. There is an increased danger of leaks!

J

Batteries must not be disposed of in the normal domestic waste!

J

Every consumer is legally obliged to dispose of batteries in the proper manner!

J

Keep batteries away from children; do not throw them in the fire, short-circuit them or take them
apart.

J

If the above instructions are not complied with, the battery may discharge themselves beyond
their end voltage. There is then a danger of leaking. If the battery have leaked inside your
device, you should remove them immediately in order to prevent damage to the device!

J

Avoid contact with the skin, eyes and mucous membranes. Any parts of the body coming into
contact with battery acid should be rinsed off with copious amounts of water and / or a doctor
contacted if necessary!

Q

Before use

Q

Insert / change battery

j

Remove the cover of the battery compartment

3

by pulling it off in the direction of the arrow

(see illustration).

j

Insert a micro battery (AAA 1.5 V).

Note: Please observe the correct polarity. This is indicated in the battery compartment.

j

Then close the battery compartment again.

Q

Operating instructions

Q

Measuring D, C, AA and AAA battery

j

Place a battery of the type D, C, AA or AAA in the battery tester (see fig. A).

Note: In doing so, please observe the correct polarity. This is shown on the battery tester.

Note: Please ensure for proper contact between the battery and the battery tester.

j

Secure the battery by means of the extendable contact arm

1

(see fig. A).

j

Read the voltage of the connected battery using the voltage display

5

and the 1.5 V scale

4

.

Q

Measuring 9 V battery

j

Position the 9 V battery on the test contacts

7

(see fig. B).

Note: In doing so, please observe the correct polarity. This is shown on the test contacts

7

.

Note: Please ensure for proper contact between the battery and the test contacts

7

.

j

Read the voltage of the connected battery using the voltage display

5

and the 9 V scale

6

.

Advertising