Powerfix Z25679A/Z25679B - Handbuch (Seite 4)

4 GB/IE/CY
Safety advice / Prior to assembly / Assembly
The fly screen panels 3 may tear off. This can
result in injury and / or damage.
J CaUTION! FIrE HaZarD! Do
not light an open fire anywhere near
the product.
J
Do not hang anything on the product.
J
First make sure that the material of your door is
suitable for installation of self-adhesive materials.
J
Take care that you do not get caught on the fly
screen panels 3 when you pass through, since
they may otherwise tear off.
Q
Prior to assembly
j Keep the loop tape 5 and fixing rail 2 out of
direct sunlight prior to assembly. Excessive heat
can diminish the strength of the adhesive strips.
j Clean the door frame thoroughly before install-
ing the product. The door frame must be clean,
free from grease and dry before you install the
fixing rail
2 or the loop tape 5 on it. If this is
not the case, the strength of the adhesive strips
may be reduced.
Q
assembly
Q
Permanent installation
of the door fly screen
CaUTION! rISK OF INJUrY! You will
need a saw for this part of assembly. Please make
sure that you consult the operating instructions for
your saw and use protective gloves.
j First measure the width of your door using a
tape measure (see Fig. A).
Note: The product is suitable for doors with a
maximum width of 100 cm.
j Shorten the fixing rail 2 and cover 1 to the
required width using a saw (see Fig. B).
j Remove the cover 1 from the fixing rail 2
(see Fig. C)
j Remove the protective film from the adhesive
strip on the back of the fixing rail 2 and stick
the fixing rail 2 directly onto the door frame
(see Fig. C - E). Use a spirit level if necessary.
j Wait 2 hours before continuing with assembly.
j Measure the height of your door using a tape
measure (see Fig. F).
Note: The product is suitable for doors with a
maximum height of 220 cm.
j Remove the protective film from the adhesive
strip on the front of the fixing rail 2 .
j Stick the fly screen panels 3 onto the adhesive
strip on the fixing rail 2 (see Fig. F).
Note: Take care that the fly screen panels 3
overlap by at least 10 cm.
Note: Take care that the fly screen panels 3
end at floor level. Any excess fly screen should
protrude at the top.
j Cut off any excess fly screen (see Fig. G).
Note: Always cut off excess fly screen at the
top - never at the bottom. The fly screen panels
3 may otherwise fray.
j Place the cover 1 on the fixing rail 2
(see Fig. H).
Q
Temporary installation of the
door fly screen
CaUTION! rISK OF INJUrY! You will need
a saw for this part of assembly. Please make sure
that you consult the operating instructions for your
saw and use protective gloves.
j First measure the width of your door using a
tape measure (see Fig. A).
Note: The product is suitable for doors with a
maximum width of 100 cm.
j Shorten the fixing rail 2 and cover 1 to the
required width using a saw (see Fig. B).
j Shorten the loop tape 5 and hook tape 4 to
the required width with a pair of scissors.
j Remove the protective film from the adhesive
strip on the loop tape 5 and stick the tape
onto the door frame (see Fig. I). Use a spirit
level if necessary.