Emerson Process Management El-O-Matic E and P Series E25-E950 - Handbuch (Seite 16)

Data sheet
Copyright © Emerson Process Management. The information in this document is subject to change without notice.
Updated data sheets can be obtained from our website
www.El-O-Matic.com or from your nearest Valve Automation Center USA: +1 813 319 0266 Europe: +31 74 256 10 10 Asia-Pacific: +65 6501 4600
www.El-O-matic.com
Sheet No.:
Date: January 2010 A1.101.71 Rev. B HIGH TEMPERATURE ACTUATOR SPECIFICATIONS
-20°C / +120°C
-4°F / +248°F
Viton
FPM
Sealings
Castrol
LMX
Grease
Description
A double piston, rack and pinion pneumatic actuator incorporating a three point piston support
system, anti-blowout spindle and with high duty synthetic bearings at all bearing points.
This version is a standard aluminum actuator, but incorporating parts and materials suitable for
high temperature operation.
Specification
Max. pressure
: 8 bar ~ 120psi
Torque : Standard
Media : Air or non corrosive gas
Temperature : -4°F to +248°F (-20°C to +120°C)
Finish : Polyester non-TGIC based powder coating (see data sheet A4.204.01)
Spare parts
Dedicated high temperature spare parts are available for maintenance or make a standard
actuator suiteable for high temperature operation.
Materials
Part Material Specifications Remark
Housing Aluminum Alloy UNS A13600, ASTM B85
Drive Shaft
Aluminum Alloy UNS 1 77075, ASTM 7075 T6 Hard anodized
Steel (180° rotation) ETG100 or 42CrMo4V XM Zinc Plated type > P750
Stainless Steel Sandvic 1802, SS2382 or X35CrM017 type > E950
Piston Aluminum Alloy UNS A03560, ASTM B26
Sealings Viton FPM O-rings -/-
Grease Castrol LMX -/-
Shaft bearings
Top : Delrin POM
Bottom : Nylatron PA6.6 + MoS2
Piston bearings PTFE 25% Carbon filled
Bodybearings
PTFE (“P” serie) 25% Carbon filled
Nylatron (“E” serie) PA6.6 + MoS2
Shaft thrust washer ZEDEX 100 K -/-
End cap bolts
Stainless Steel (“E” serie) AISI 304 A2
Alloy Steel (“P” serie) 8.8 DIN 912 Deltatone ® coating
Springs Carbon Spring Steel UNS G10860, ASTM A228 Deltatone ® coating