Water-stop device, Water drainage – Electrolux LAVAMAT 76650 A3 Benutzerhandbuch
Seite 33
3. Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.
4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied
with the appliance.
The inlet hose must not be lengthened. If it
is too short and you do not wish to move
the tap, you will have to purchase a new, lon
ger hose specially designed for this type of use.
Installation should comply with local water
authority and building regulations require
ments. Check the minimum water pressure
required for safe operation of the appliance
in the chapter "Technical Data".
Water-stop device
The inlet hose is provided with a water stop de
vice, which protects against damage caused by
water leaks in the hose which could develop due
to natural ageing of the hose. This fault is shown
by a red sector in the window
«A» . Should this
occur, turn the water tap off and refer to your
Service Centre to replace the hose.
Water drainage
The end of the drain hose can be positioned in three ways:
1.
Hooked over the edge of a sink using the plastic hose guide supplied with the
machine.
In this case, make sure the end cannot come unhooked when the machine is emptying.
A
Installation
33