MITSUBISHI ELECTRIC SKM35ZD-S - Handbuch (Seite 13)

– 12 –
ON-TIMER operation procedure
HI POWER TEMP ECONO
AIR FLOW
CANCEL
ON OFF RESERVE
TIMER
TIME ACL
FAN SPEED
ON
MODE
LO
MED
HI
AUTO
TIME
OFF
HI POWER ECONO
ON
AM
1
2
Changing of set time
Set a new time by using the ON TIMER button.
Example: In the case you wish to bring the temperature to nearly set temperature in at AM 8:00.
Press the ON TIMER button.
ON TIMER indicator
ON
is blinking.
Press the “ or ” button.
Each time the button is pressed, the indicator is switched in the order of:
AM
0:00 AM
0:10 AM
0:20 ... ... AM
1:00 AM
1:10
Each time the button is pressed, the indicator is switched in the order of:
AM
0:00 PM
11:50 PM
11:40 ... ... PM
11:00 PM
10:50
Set at AM 8:00.
Press the RESERVE button.
The indication changes from blinking to steady lighting and the setting is complete.
The timer light (yellow) is on.
⇓
• Operation starts 5 to 60 minutes before the set time.
• The TIMER light goes out at the set time.
Releasing procedure
Press the CANCEL button to turn off the timer indicator.
3
Program TIMER operation procedure
■ The timer operations that consist of the combination of the timer being set at both on and off. Once this has been set and operations started,
operations will commence and end at the same time every day as long as the ON/OFF button is not pressed.
Example: When it is desired to stop at 10:30 PM, and then start operation at 8:00 AM,
near the set temperature.
Press the ON/OFF button.
■ OFF TIMER operation setting
Set by the procedures on page 11.
Set to
OFF
PM
.
■ ON TIMER operation setting
Set by the above mentioned ON TIMER operation procedures.
Set to
ON
AM
.
The setting of the lighting of the timer lamp (yellow) of this unit is complete.
The time will be displayed on the remote control unit. The display will change
depending on the operational status.
ON OFF ON OFF
1
(Stopped) (Operating)
Changing of set time
Set a new time by using the OFF TIMER or ON TIMER button.
Releasing procedure
Press the CANCEL button to turn off the timer indicator.
HI POWER TEMP ECONO
AIR FLOW
CANCEL
ON OFF RESERVE
TIMER
TIME ACL
FAN SPEED
ON
MODE
LO
MED
HI
AUTO
TIME
OFF
HI POWER ECONO
ON OFF
PM
■ If the room temperature is at near optimum temperature at the set time, the operation starts 5 to 60 minutes before the set time. Page 13
RWA012A226_En 03.8.27, 6:47 PM 12