Kompernass KH 280 - Handbuch (Seite 8)

8 GB / IRL
The charge indicator T shows red to indicate
that the device is positioned correctly in the
cradle and that the charging cycle has started.
Note: Ensure that the On/Off switch Y is set
to Off before starting with the charging cycle.
Important:
˼ Only return the device to the charging
station
I if a single light diode of the battery’s
charge indicator R lights up.
Important advice about the battery:
˼ In the event that your battery is defective,
please contact our Service Centre directly.
The service centre for your country is shown
on the enclosed guarantee card.
˼ Please do not send in the whole device. Just
send the defective battery.
Remove the batteries as shown in pic. A.
Summary
Note: Always make sure that the dust fi lter W
is installed before you use the appliance.
1. To open the front nozzle Q press the dust
container release button E and remove the
front nozzle Q . Check that the dust fi lter is
installed and slide the front nozzle Q back
into place.
2. If you need to use the crevice tool P or the
small brush { , they can be inserted into the
nozzle opening Q .
Use
1. Remove the vacuum cleaner from the
charging
station I .
2. To operate the appliance, slide the On/off
switch
Y into the On position.
3. After use slide the On/off switch Y into the
Off position.
4. The small brush { and the crevice tool P are
used to clean narrow diffi cult to reach places.
5. If all the four LEDs in the battery charge
indicator light up, then the batteries are fully
charged. The fewer LED indicators light up,
the lower is the remaining battery capacity.
Important:
If, during operation of the appliance, only one
LED lights up, then this shows that the battery
capacity is low. In this event, the batteries should
be recharged.
Cleaning
Replacing and cleaning the dust fi lter
To obtain the best performance from your vacuum
cleaner, empty the dust container
Q and clean
the dust fi lter W after every use.
1. To open the front nozzle Q , press the dust
container release button E and remove the
dust container Q .
2. Take out the dust fi lter W .
3. Empty the dust container Q .
4. Rinse the dust fi lter W in cold water and wait
until it is completely dry again before replac-
ing it into the dust container Q .
Operation / Cleaning