Zanussi ZOS 35802 XD - Handbuch (Seite 5)

Before first use
Warning! Refer to "Safety information"
chapter.
Initial cleaning
• Remove all accessories and removable shelf
supports (if applicable).
• Clean the appliance before first use.
Important! Refer to the chapter "Care and
cleaning".
Setting the time
You must set the time before you operate
the oven.
When you connect the appliance to the electri-
cal supply or after a power cut, the indicator for
the Time of Day function flashes.
Press the + or - button to set the correct time.
After approximately five seconds, the flashing
stops and the display shows the time of day
you set.
To change the time, press again and
again until the indicator for the Time of Day
function flashes. You must not set the Duration
or End function at the same time.
Preheating
Preheat the empty appliance to burn off the re-
maining grease.
1. Set the function and the maximum tem-
perature.
2. Let the appliance operate for one hour.
3. Set the function and the maximum tem-
perature.
4. Let the appliance operate for ten minutes.
5. Set the function and the maximum tem-
perature.
6. Let the appliance operate for ten minutes.
Accessories can become hotter than usually.
The appliance can emit an odour and smoke.
This is normal. Make sure that the airflow is suf-
ficient.
Daily use
Warning! Refer to "Safety information"
chapter.
To use the appliance, push the knob. The knob
comes out.
Activating and deactivating the appliance
1. Turn the knob for the oven functions to an
oven function.
The power indicator comes on while the
appliance operates.
2. Turn the knob for the temperature to a tem-
perature.
The temperature indicator comes on while
the temperature in the appliance increases.
3. To deactivate the appliance, turn the knob
for the oven functions and the knob for the
temperature to the Off position.
5
www.zanussi.com