WolfVision VZ-9plus 3 User Manual - Handbuch (Seite 22)

21
One Push White Balance:
Press the LIGHT key (#4) for 2 seconds to perform one push white balance.
Activating the on-screen menu:
Press the MENU key (#50) (EXTERN key) on the camera head for 2 seconds to activate the on-screen
menu. Use the FOCUS keys (#48) to navigate and the FREEZE key (#46), PRESET key (#47) to select.
For the help function, press the AF key (#49).
Resetting the selected menu item:
For resetting only the selected item press the AF key (#49) for 2 seconds.
Storing Preset 1:
Press the PRESET key (#47) on the camera head for 2 seconds.
Recalling Preset 1:
Press the PRESET key (#47) on the camera head quickly.
CODES - Short Keys
Storing presets:
Press the desired PRESET key (#31) for 2 seconds.
Recalling presets:
Press the desired PRESET key (#31) quickly.
Storing images:
Press the desired MEMORY key (#42) for 2 seconds.
Recalling images:
Press the desired MEMORY key (#42) quickly.
Activating the on-screen menu:
Press the MENU key (#27) to activate the on-screen menu. Use the Number keys (#30) to navigate and
Number 5 key (#43) to select. For the help function, press the HELP key (#29).
Switching the output mode:
Higher mode: Simultaneously press both FOCUS keys (#48) on the camera head and the Number 2
key (arrow-up) (#30) on the remote control.
Lower mode: Simultaneously press both FOCUS keys (#48) on the camera head and the Number 8
key (arrow-down) (#30) on the remote control.
Resetting the output mode to the default of "auto resolution":
Simultaneously press both FOCUS keys (#48) on the camera head and the Number 5 key (#43) on the
remote control.
Resetting the Visualizer's menu:
For resetting the entire menu settings simultaneously press both FOCUS keys (#48) on the camera head
and the Number 4 key (back arrow) (#30) on the remote control.
For resetting only the selected item press the Number 7 key (#29) on the remote control for 2 seconds.
Change IR code:
Change the IR code in the
"Advanced Settings / Miscelaneous Settings" and set the "IR
Code" to A, B, C or D (code A is default). To change the IR code on the remote control, simultaneously press
both PRESET keys
and the ZOOM TELE key
ress PRESET 1, PRESET 2 and ZOOM
WIDE
on-screen menu
(#31) (#37). Each time this key combination is used, the code
switches from A to B, C, D ... A ... in the order given.
For resetting the remote control to code A, simultaneously p
.
The LED on the remote control shows the selected code (it flashes one time for code A, two times for code
B, three times for code C and four times for code D).
IR-Remote Control
Base and Camera head