WolfVision VZ-C3D User Manual - Handbuch (Seite 14)

13
For regular use of the WolfVision Visualizer, it is not necessary to go into the Visualizer's menu and change
settings. Inexperienced users should not make any adjustments here.
To enter the on-screen menu press the MENU key (#16). Settings of the Visualizer's basic functions and the
built-in camera can be made here using the 4 SELECT keys on the remote control (#17) and the OK key
(#28).
If more information on a function in the on-screen menu is required, set the cursor in the respective line and
keep pressed the MENU / ? key (#16) until a detailed description of this function appears on the screen. To
exit the help function, keep the MENU / ? key pressed again until the help disappears.
By pressing the MENU key for 4 seconds the Extra Menu appears. In the Extra Menu, e.g. the Factory
Reset can be performed to reset all settings including resolution and IP addresses to the default.
The functions of the on-screen menu are not described in detail in this user manual as the help menu is an
integrated part of the Visualizer's software (firmware). The information you see on your screen always
belongs to the current Visualizer firmware.
The following chapter is for experienced users only:
ON-SCREEN MENU / ON-SCREEN HELP
Exposure Settings
Color Settings
Output Settings
Preset Settings
Advanced Settings
The exposure settings will affect the brightness of the image, e.g. Gain, Shutter, Aperture, Image
Brightness and Back Light Compensation.
The Color Settings will affect the color reproduction of the camera, e.g. White Balance settings, Color Mode
and Positive/Negative.
Hint:
If the picture on your screen appears to be too light or too dark or the color saturation is not correct, the Color
Mode can be changed.
For better readability of handwritten texts, the image can be changed to BLUE.
To change the Detail Settings (sharpness) and to change the Output Resolution manually.
Hint:
Use the "Resolution Test" function to change to the selected resolution temporarily for ten seconds. This
way the compatibility of the connected display device can be easily checked.
In the "Preset Control" the Preset keys can be assigned specific functions such as "WHITE BALANCE",
BLACK/WHITE", "LIGHT", etc.. Additionally the default presets can be recalled.
In this sub-menu the behaviour when powering on, zooming, using on-screen menu can be changed and
the Height Adjustment can be performed.
Settings for Ethernet (LAN) and Date/Time will also be found in this menu.
Hint:
Change Power-Down Mode to "DEEP" to save power consumption in standby mode.
Open "Device Info" to view details of the unit like currently installed firmware version.
Recall Default Menu Settings
All picture affecting settings can be set back to the factory defaults. All settings which affect the
communication with other equipment, e.g. network settings and resolution will not be changed.
Start Quick Setup Guide
The Quick Setup Guide will be started automatically when the Visualizer is switched on the first time and
can be started with this item manually. This menu will guide you through basic settings like Height
Adjustment, language, LAN settings and time/date settings.