WolfVision VZ-C10 Installation - Handbuch (Seite 5)

When the Ceiling Visualizer is completely slid onto the tracks, tighten the holding
screws (4x M6x25 Hex-screws - see arrow) to secure the unit to the track.
Do not overtighten screws!
INSTALLATION OF WOLFVISION'S
CEILING MOUNT
For security reasons we are unable to provide fastening equipment for the ceiling mount with the
VZ-C10. We request that you acquire the appropriate fastening material for your particular ceiling
construction at your local hardware store.
WolfVision assumes no responsibility for errors or problems resulting from the use of inferior
materials, or by improper installation or mounting methods !
A ceiling mount is supplied with the VZ-C10 so the Celing Visualizer can be
mounted only 40mm to the ceiling.
Connect the carrier plate to the mounting plate (the assembly should be
centered and level). Tighten the four self-locking nuts and washers securely
with the supplied wrench.
IMPORTANT: Only use the self-locking nuts, supplied with the assembly!
Fixing the assembly to the room ceiling is dependent on the particular
construction and circumstances of the desired mounting location. In any event, it
is recommended that the fastening system used should support 80Kg minimum
in order to eliminate the possibility of accidents from bumping the unit or other
unforeseen problems.
Carefully slide the tracks of the Ceiling Visualizer onto the adapter plate until the
plate-track assembly is properly in place.
The tracks must not be removed!
IMPORTANT: Ensure solid mounting and connection of all parts to avoid the possibility of the
unit falling and causing severe injury or damage !
Also give special attention to the country specific regulations for schools
and conference rooms !
The supplied adapter plate can be quickly mounted to most
ceiling mounts. The ceiling mount should be centered and
leveled to avoid tipping of the VZ-C10.
Minimum distance between holes: 25x25mm (1"x1")
Maximum distance between holes: 240x200mm (9.5"x7.9")
5
G