WolfVision VZ-C10 Installation - Handbuch (Seite 7)

OPERATION OF THE VISUALIZER
On the display screen, the On-Screen Menu of the Visualizer appears (First time the unit is turned on):
“Step 1: Center the Lightfield”
Center the lightfield until it is roughly in the center of the camera picture.
Use the arrow buttons (MEMORY 2/4/6/8) to center the lightfield.
Confirm the setting by pressing the MEMORY 5 key (#21).
“Step 2: Adjust Camera Focus”
Use the FOCUS button (#17) until a sharp image is visible.
Confirm the setting by pressing the MEMORY 5 key (#21).
“Step 3: Adjust Light Focus”
With the FOCUS key (#17), you can focus the edge of the lightfield that is visible on the working surface until it is sharp.
Again confirm the setting by pressing the MEMORY 5 key (#21).
“Step 4: Center light field”
With the arrow buttons (Memory 2/4/6/8) you can center the lightfield with the picture.
When the lightfield is centered, press the MEMORY 5 key (#21) to complete the setting procedure and exit the Height
Adjustment mode.
The Height Adjustment procedure can be repeated at any time. Just press the MENU button (#19) for one second. Select
Height Adjustment with the arrow keys (MEMORY 2/8), enter the Height Adjustment (MEMORY 4/6) and use the arrow
keys (MEMORY 4/6) again to change the “Height Adjustment Protect” to “OFF”. Then select “Start Height Adjustment” and
repeat steps 1-4.
Height Adjustment (using On-Screen Menü)
7
1. Connect the cable to the unit (#28) and the other end to the network.
2. If you wish to connect a control monitor, please use the following connections:
Computer Monitor: Preview RGBHV Output (#32)
Video Monitor: Y/C (S-Video) or Composite Video Output (#36, 37).
3. Connect the primary monitor or video projector to the output of the Visualizer.
To select the proper output, please read the operation manual !
4. Switch the main power (#26) on the unit to "I".
5. Turn on the unit using the POWER button (#23) on the remote control.
The first time the unit is switched on, the "Height Adjustment" program is started automatically. The VZ-C10 is pre-
programmed for a default distance of 2 m. Because the actual mounting height is usually different form the preset value,
the following setting adjustments should be made:
1. Setting the Camerafocus and Lightfocus
2. Adjustment of the Lightfield-Centering to the Camerafield
It is only necessary to conduct the setting procedure once, unless the distance between the Visualizer and working
surface is changed:
POWER
MEMORY
MENU
HELP
19
22
23
21
17 17