WolfVision VZ-C10 Installation - Handbuch (Seite 6)

If the Visualizer needs to be hung further from the ceiling than with the supplied ceiling mount, (in order to allow
greater magnification), a standard ceiling mount for projectors can be used. The VZ-C10 is equipped with a flexible
mounting fixture that is compatible with almost every projector ceiling mount model.
Fixing the assembly to the room ceiling is dependent on the particular construction
and circumstances of the desired mounting location. In any event, it is
recommended that the fastening system used should support 80Kg minimum in
order to eliminate the possibility of accidents from bumping the unit, or other
unforeseen problems !
Also give special attention to the country specific regulations for schools and
conference rooms !
Center the supplied pre-mounted adapter plate and loosen the four middle safety
nuts.
Insert all four bolts of the adapter plate into to corresponding holes of the ceiling
holder, and on each place the provided washers and self locking nuts (see
Arrows). The adapter plate should be centered to the ceiling holder and screwed in
place. All eight safety nuts must be firmly tightened (Do not overtighten!).
When the Ceiling Visualizer is completely slid onto the tracks, tighten the holding
screws (4x M6x25 Hex-screws - see arrowl) to secure the unit to the track.
Do not overtighten screws !
6
IMPORTANT: Ensure solid mounting and connection of all parts to avoid the possibility of the
Unit falling and causing severe injury or damage !
Carefully slide the tracks of the Ceiling Visualizer onto the adapter plate until the
plate-track assembly is properly in place.
The tracks must not be removed!
G
INSTALLATION OF AN EXTERNAL
CEILING MOUNT