WolfVision VZ-C32 Installation - Handbuch (Seite 11)

3 mounting
plate hex nuts
6 clamping nuts
+/- 45°
+/- 30 mm +/- 30 mm
+/- 30 mm +/- 30 mm
stabilization ring with
2 Allen screws
The Visualizer can be readjusted if necessary.
By loosening both Allen screws the unit can be turned by 45 degrees to the left or right (please
make sure that both Allen screws are retightened after readjustment). The Visualizer can also be
moved backwards or forwards +/- 30mm (1.18") by loosening the three mounting plate hex nuts
on the steel anchors (please make sure that the mounting plate hex nuts are retightened again
after readjustment).
Also, the Visualizer can be moved to the right or left by loosening the six clamping nuts (again,
please make sure that these clamping nuts are retightened afterwards). Two of the six clamping
nuts are accessible by releasing the unit only.
10