AEG SKZ81800F0 - Handbuch (Seite 22)

Problem Possible cause Solution
The compressor does
not start immediately
after pressing the
COOLMATIC or
FROSTMATIC switch,
or after changing the
temperature. This is normal, no error has
occurred. The compressor starts after
a period of time.
Water flows on the
rear plate of the re-
frigerator. During the automatic de-
frosting process, frost de-
frosts on the rear plate. This is correct.
Water flows into the
refrigerator. The water outlet is clog-
ged. Clean the water outlet.
Products prevent that wa-
ter flows into the water
collector. Make sure that products do
not touch the rear plate.
The temperature in
the appliance is too
low/high. The temperature regulator
is not set correctly. Set a higher/lower temper-
ature.
The door is not closed cor-
rectly. Refer to "Closing the
door".
The product temperature
is too high. Let the product tempera-
ture decrease to room tem-
perature before storage.
Many products are stored
at the same time. Store less products at the
same time.
The temperature in
the refrigerator is too
high. There is no cold air circula-
tion in the appliance. Make sure that there is cold
air circulation in the appli-
ance.
The temperature in
the freezer is too
high. Products are too near to
each other. Store products so that
there is cold air circulation.
There is too much
frost. Food is not wrapped cor-
rectly. Wrap the food correctly.
The door is not closed cor-
rectly. Refer to "Closing the
door".
The temperature regulator
is not set correctly. Set a higher temperature.
Upper or lower
square is shown in
the temperature Dis-
play. An error has occurred in
measuring the tempera-
ture. Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not be
possible).
22