AEG SKZ81440C0 - Handbuch (Seite 37)

Problem Possible cause Solution
Water flows on the
rear plate of the re-
frigerator. During the automatic de-
frosting process, frost de-
frosts on the rear plate. This is correct.
The temperature in
the appliance is too
low/high. The temperature regulator
is not set correctly. Set a higher/lower temper-
ature.
The door is not closed cor-
rectly. Refer to "Closing the
door".
The product temperature
is too high. Let the product tempera-
ture decrease to room tem-
perature before storage.
Many products are stored
at the same time. Store less products at the
same time.
The temperature in
the refrigerator is too
high. There is no cold air circula-
tion in the appliance. Make sure that there is cold
air circulation in the appli-
ance.
Upper or lower
square is shown in
the temperature Dis-
play. An error has occurred in
measuring the tempera-
ture Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not be
possible).
dEMo appears on the
Display. The appliance is in dem-
onstration mode (dEMo). Keep pressed approximate-
ly 10 sec. the OK button
since a long sound of buz-
zer is heard and the Display
shut off for a short while:
appliance start works regu-
larly
REPLACING THE LAMP
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service Cen-
ter.
CLOSING THE DOOR
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH
37