Festo DRQD-40 ... 50-... - Handbuch (Seite 45)

DRQD−...
Festo DRQD−... 0907e English
45
S Compare the maximum values specified in these operating instructions with
your actual application (e.g. pressures, forces, torques, temperatures, masses,
speeds).
Operation of the product in compliance with the relevant safety regulations is
contingent on adherence to the load limits.
S Take into consideration the ambient conditions at the location of use.
Corrosive elements in the environment (e.g. ozone) will reduce the service life
of the product.
S Make sure that the compressed air is properly prepared (è Technical data).
S Maintain the selected medium for the complete service life of the product.
Example: always use non−lubricated compressed air.
S Pressurise your entire system slowly.
There will then not be any uncontrolled movements.
For slow start−up pressurisation use safety start−up valve type HEL.
For vertical installation:
S Make sure that the slide has reached a stable position when it comes to a stop
(e.g. the lowest point or secured with external stops).
S Please comply with trade association regulations and national and local safety
laws and regulations.
S Remove all transport packaging such as foils, caps and cartons (except for any
plugs in the pneumatic connections).
The packing is intended for recycling (except for: oiled paper = other waste).
S Use the product in its original condition without unauthorized modifications.
S Note the warnings and instructions on the product and in the relevant
operating instructions.
S Take the tolerance of the tightening torques into account. Unless otherwise
specified, the tolerance is ±20%.
S Do not modify any screws or threaded pins unless this is requested in these
instructions.
For safety reasons they are fixed with screw locking compound.