Lenze 2003 Setpoint integrator - Handbuch (Seite 22)

20
3 Handling
3.1 Installation and connection
The 2003 option module can be attached to all 470/480 controllers
equipped with spacer bolts.
The voltage (+V
CC
, -V
CC
, GND) is supplied via the spacer bolts.
The fourth spacer bolt is connected to controller inhibit. The
instrument is equipped with the required spacer bolts before
delivery.
•
Remove the protection cover.
Caution!
The protection cover may only be removed and the instrument
may only be assembled by qualified personnel and when no
voltage is applied. After assembly the protection cover must
be reattached.
•
Adjust the spacer bolt for -V
CC
and the spacer screw M3x25,
which are in the assembly kit, to the other bolt lengths.
Attachment to the 47x controller:
•
Position the setpoint integrator on the spacer bolts and fasten it
with the four tooth-lock washers and the spacer screws M3x25
from the assembly kit (see the following figure).
Please observe that the terminal strips of both boards (470x and
2003) have the same direction.
6
7
8
1
2
3
4
5
➀ Plastic screw
➁ Protection cover
➂ Spacer screw M3x25
➃ Tooth-lock washer M3
➄ 2003 option board
➅ Spacer bolt
(preassembled in factory)
➆ 470 basic board
➇ Screw with washer assembly
Attachment to the 48x controller:
•
Extend the outer spacer bolts, which are used to fasten the
protection cover, with the spacer screws M4x25 from the
assembly kit.
•
Position the setpoint integrator on the inner spacer bolts and
fasten it with the four tooth-lock washers and the spacer screws
M3x25 from the assembly kit.
Please observe that the terminal strips of both boards (470x and
2003) have the same direction.