Clearaudio BALANCE AMPLIFIER - Handbuch (Seite 16)

Balance Amplifier
Bedienungsanleitung/Instruction Manual
Seite/Page 16  clearaudio electronic GmbH 2006
4. Installation and set up
Please place the amplifier in the centre of your Hifi components (so that the cables are
in the same length). Please pay attention, that you have at least a 10 cm distance
between the top side of your amplifier and your upper layer of your rack (the amplifier
is a Class A version, and there needs to be enough air circulation!).
Please connect now all connections from your Hifi components.
Important:
Make sure that before you connect the main cable, your main voltage from
the amplifier would be the same as your main power supply system!
Connect the output from your preamplifier with the appropriate input from your
amplifier.
You can choose between various connecting- and mode-types as shown below.
4.1. Stereo-mode unsymmetric (RCA):
input selector (9) pressed, mode selector (10) not pressed.
The music-signal will be connected with RCA-input unbalanced (11), the
speakers will be connected with the white and red speaker terminals (12), each.
11 11
12 12
9 10