Clearaudio BALANCE AMPLIFIER - Handbuch (Seite 21)

Balance Amplifier
Bedienungsanleitung/Instruction Manual
Seite/Page 21  clearaudio electronic GmbH 2007
6. Technical Specifications:
The correlation between published specifications and performance is unreliable.
Measurements of your amplifier yield excellent results by any standards. However, only
those specifications that apply to its actual operation are included here.
Rated power output:
2 x 50 W/ 8 Ω pure class A
2 x 94 W/ 4 Ω class A
1 x 160 W/ bridged mode 8 Ω
Frequency response:
from 20 Hz to 20 kHz (- 0,2 dB)
Signal to noise ratio
100 dB linear
(main outputs):
Distortion factor:
0,02 % with 1/10 power rating
Input impedance:
balanced and single-ended 10 k Ω
Gain: 34,4 dB
Input sensitivity:
370 mV for full output power
Power consumption:
250W (±5%) at idle,
150W (±5%) in standby
mains voltage:
determined by the needs of country
(115 V or 230 V)
which the unit was manufactured for;
cannot be reset by dealer or user
Overall dimensions (mm): 435x220x270
Connector complements:
four custom binding posts
two 3-pin XLR balanced input connectors
two RCA input connectors
Weight: 30 kg
Warranty: 5 years *
All specifications are subjected to change at any time, in order to improve the product
without notice.
* Only if the warranty card is filled out correctly and sent back to clearaudio. Please see
Point 5!