Clearaudio BALANCE AMPLIFIER - Handbuch (Seite 18)

Balance Amplifier
Bedienungsanleitung/Instruction Manual
Seite/Page 18  clearaudio electronic GmbH 2006
4.4. Mono-bridged symmetric:
Input selector (9) not pressed, mode selector (10) pressed.
The music-signal will be connected with the XLR-input (8) left channel,
connection to the speakers connect them with both red speaker output (12).
In the normal stereo mode please use the red and white speaker outputs for the left
and right channel.
If you use the amplifier in the mono-bridged mode, you must connect the
speaker with the red speakers output connectors, the plus connector is the
red connector from the left output and the minus connector is the red
connector from the right output, to speakers.
In the bridged mode, the impedance of the speakers should be
not lower than 4
Ω
!
Damage of the fuses might occur!
At next you set the connection to your speakers.
If all connections are fixed you can turn on the amplifier with the
“power” (13) switch on his back.
After the switch on, the amplifier would be in the „Standby” mode.
8
12 12
9 10
13
plus-
connection
to speaker
minus-
connection
to speaker