Clearaudio VTA LIFTER 2 - Handbuch (Seite 4)

VTA – Lifter 2
NEW
User manual / Bedienungsanleitung
Seite/Page 4
 clearaudio electronic GmbH 2013
2. Installation on Clearaudio turntables
2.1. Installation on a Solution base
For the installation please remove the tonearm and the base from your turntable.
Fit the VTA-Lifter (2) from above through the hole of the base.
Please mount the VTA-Lifter (2) with the lever rearwards (see pic 1).
Tighten the VTA-Lifter (2) with the delivered cylinder head bolts and the hex key wrench (3
x 8) on the bottom side of the Solution – base (see pic. 2).
Now you can mount the Solution base on the turntable chassis again.
2.2. Tonearm set up (only for clearaudio Radial tonearms)
To install a clearaudio radial tonearm (e.g. Unify, Satisfy and Universal) please pull the cable
carefully trough the hole of the VTA-Lifter (2) .
After you have set up the tonearm into the hole please make sure that the tonearm is
exactly on the line between “+” and “-“(top view) (see pic. 3) on the VTA-Lifter (2) .
Bild (Tonearm
Bild mit Tonarm
Pic. 1: Mounting the VTA-Lifter in a Solution base
Lever
Pic. 2: Tighten the VTA-Lifter in a Solution base
Bottom side of the Solution base
Pic. 3: Assembly of the tonearm