Pilz PSEN op67-69K-135/1 - Handbuch (Seite 15)

EN
1002401-2EN-01
PSEN op67-69K
Operating instructions
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany 3
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected] Original document
Assembly
First of all, remove end caps d from subassemblies b und c and
then remove subassemblies b and c from tube a. Having taken
these steps, the unit should be in the condition illustrated in Fig. 1.
a Transparent PMMA tube
b Lower bracket
c Upper bracket
d End cap with OR
e INOX rotating bracket
Fig. 1
Position the M5 square nuts on the inside of the bracket blade,
aligned with the holes, and affix the screws TE M5x6 UNI 5739 (and
special washers), but do not tighten them, leaving room for
manoeuvre (Fig. 2 and Fig. 3).