Pilz PSEN op67-69K-135/1 - Handbuch (Seite 16)

EN
1002401-2EN-01
PSEN op67-69K
Operating instructions
4 Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected] Original document
Fig. 2 Fig. 3
Then insert the spacers into the lateral grooves of the PILZ safety
light curtain as far as the end (Fig. 4) and tighten the screws to
attach the light curtain to c. Repeat the same step for part b; make
sure that the safety light curtain cable (which must be connected
before starting the light curtain assembly) is guided through the
relevant hole of the M16 cable conduit before tightening the screws
(Fig. 5).
Fig. 4 Fig. 5
When both parts b and c are fully installed on the light curtain,
tighten the nut to secure the cable. Check again that the M5x6 UNI
TE 5739 screws are firmly seated.
If the system looks like the illustration in Fig. 6, it can be placed
inside the transparent tube (Fig. 7).
M5 square nut
M16 cable conduit with ring nut,
untightened
Elastic
washer
TE M5x6 UNI 5739 screw