Pilz PSEN op67-69K-135/1 - Handbuch (Seite 17)

EN
1002401-2EN-01
PSEN op67-69K
Operating instructions
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany 5
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected] Original document
Fig. 6 Fig. 7
Now prepare the two end caps with the relevant OR gasket, as
illustrated in Fig. 8, and attach to the top and bottom of the PMMA
tube.
Fig. 8 Fig. 9
Complete the assembly by tightening the 4 screws INOX TCEI
M4x18 UNI 5931 on both sides, so that the OR gasket is completely
pressed against the inside of the tube (Fig. 9).
To install the brackets, position them on both end caps, aligned
with the middle hole of the respective bracket, and tighten them in
the required angular position using the 3 screws INOX TCEI M4x8
UNI 5931 (Fig. 10).
INOX TCEI screw
M4x18 UNI 5931