8 testing procedure – ALTANA Pendulum Hardness Tester Manual Benutzerhandbuch
Seite 20
Advertising
19
Testing procedure
8 Testing
procedure
• Mount the wire release at 12°
• Choose the appropriate method with the mode
button.
• Choose the required signal options
• Place the sample on the lifting table.
• Raise the table to the stop.
• Move the pendulum to the 12 ° position and
hold it with the wire release.
• Start Measurement. By pressing the start
button.
• Release the pendulum with the wire release.
The signal starts at the end of measurement and
the result is shown on the display.
English
Advertising